Care And Cleaning - Marvel MP24RDS3 Série Instructions D'installation, D'utilisation Et D'entretien

Step 4: Install the Lock
Two (2) lock extensions are provided with the lock. Use the
longer extension for ⁄ " thick overlay panels and the shorter
3
4
one for ⁄ " thick overlay panels. Assemble the lock exten-
5
8
sion, cam stop washer, spring washer, and set screw to the
lock as shown in Figure 20 and 21.
Install this lock assembly into the lock hole in the overlay
panel and secure with the retaining nut on the back side
with a 15 mm socket and ratchet. Make sure the key slot in
the front of the lock is vertical.
3/4 INCH
WOOD PANEL
13/16 COUNTERBORE
1/2 HOLE
NUT
SPRING
LOCK
WASHER
BRASS EXTENSION
Figure 20
Spring
washer
Retainer
nut
Key
Lock
Figure 21
Step 5: Reinstall the Drawers
1. Fully extend drawer slides and place drawer on slides.
Be sure that drawer sits evenly on both slides and clips
slide into place in rear of drawer.
2. Re-install wire harness at rear corner of top drawer.
3. Re-install two screws through drawer into slides.

CARE AND CLEANING

INNER
DOOR
PHILLIPS SCREW
CAM
Screw
Cam
Brass
extension
(2 lengths
provided)
Cam stop
Set screw
washer
Care of Appliance
1. Avoid leaning on the drawer, you may bend the drawer
hinges or tip the appliance.
2. Exercise caution when sweeping, vacuuming or mop-
ping near the front of the appliance. Damage to the
grille can occur.
3. Periodically clean the interior of the appliance as
needed.
4. Periodically check and/or clean the front grille as
needed.
Front Grille
Be sure that nothing obstructs the required air flow open-
ings in front of the cabinet. At least once or twice a year,
brush or vacuum lint and dirt from the front grille area (see
page 4).
CAUTION
!
SHOCK HAZARD: Disconnect electrical power from the
appliance before cleaning with soap and water.
Cabinet
The painted cabinet can be washed with either a mild soap
and water and thoroughly rinsed with clear water. NEVER
use abrasive scouring cleaners.
Interior
Wash interior compartment with mild soap and water. Do
NOT use an abrasive cleaner, solvent, polish cleaner or
undiluted detergent.
In the Event of a Power Failure
If a power failure occurs, try to correct it as soon as pos-
sible. Minimize the number of drawer openings while the
power is off so as not to adversely affect the appliance's
temperature.
Light assembly replacement
All models use an LED to illuminate the interior of the ap-
pliance. This component is very reliable, but should it fail,
contact a qualified service technician for replacement of the
LED.
16