Assembly And Operation - Worx WX665L Mode D'emploi

SYMBOLS
WARNING–To reduce the risk of
injury, user must read instruction
manual
Warning
Wear ear protection
Wear eye protection
Wear dust mask
Double insulation
Before working with your tool make
sure that no power cords will be
damaged.
Avoid danger of injury from the
sharp edges of the accessories.
Accessories can become very hot
while working, presenting danger
of burns!
Make sure the tool is unplugged
prior to changing accessories.
Wear protective gloves
High oscillation frequency
Low oscillation frequency
High Frequency Oscillating Tool
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.

ASSEMBLY AND OPERATION

Action
Mounting Accessories
--Loosen the flange
--Insert accessories
--Tighten the flange
Mounting/Changing the
Sanding Sheet
Mounting The Suction
Device
Operating The On/Off
Switch
Using the Variable
Speed Dial
Sawing with End Cut
Blade
The Variable Speed Dial can be used to set the
optimum oscillating frequency according to the
accessories used and the respective application.
Oscillation
frequency
High oscillation
frequency:
Low oscillation
frequency:
Figure
See Fig. A1
See Fig. A2
See Fig. A3, B
See Fig. C
See Fig. D
See Fig. E
See Fig. F
See Fig. G
Application
Sanding, sawing,
rasping and polishing
stone and metal.
Scraping, polishing
varnishes.
EN
9