Intended Use; Assembly And Operation - Worx Sonicrafter WX693 Mode D'emploi

Accessories can become very hot
while working, presenting danger
of burns!
Make sure the battery is
removed prior to changing
accessories.
Wear protective gloves
High oscillation frequency.
Low oscillation frequency.
LED light is a battery capacity
=
indicator and will flash when power
- - -
- - -
gets low .
Waste electrical products should
not be disposed of with household
waste. Please recycle where fa-
cilities exist. Check with your Local
Authority or retailer for recycling
advice.
xINR18/65-y: Cylindrical lithium Ion battery
cells with max diameter of 18mm and max
height of 65mm; "x" represents a number cells
serial connected, blank if 1; "-y" represents a
number of cells paralleled connected, blank if 1.
Oscillating Tool
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.

INTENDED USE:

The power tool is intended for sawing and
remodelling wooden materials, plastic, plaster, non-
ferrous metals and fasteners (e.g. nails and clamps)
as well as for working on soft wall tiles and for dry
grinding of small surfaces. It is especially suitable for
working close to edges and for flush cutting.

ASSEMBLY AND OPERATION

Action
Mounting accessories
Mounting the sanding sheet
Operating the on/off switch
Using the variable speed dial
Remove or install battery pack
LED Light
The Variable Speed Dial can be used to set the
optimum oscillating frequency according to the
accessories used and the respective application.
Oscillation
frequency
High oscillation
frequency:
Low oscillation
frequency:
Figure
See Fig. A-C
See Fig. D
See Fig. E
See Fig. F
See Fig. G
See Fig. H
Application
Sanding, Sawing, Rasping
and Polishing Stone and
Metal.
Scraping, Polishing
Varnishes.
EN
7