Change Of Door Opening Direction - AEG A75100GA4 Mode D'emploi

Change of door opening direction

Should the setting-up place or handling demand it, door-opening direction
can be refitted from right-handed to left-handed.
Following operations are to be done on the basis of figures and explanations:
Pull out the plug from the mains
socket.
Tilt back the appliance carefully being
careful so that the compressor can not
touch the floor. It is recommended to
ask another person for help, who can
keep the appliance at this position
safely.
Unscrew the adjustable feet situated
on both sides (2 pieces), in addition
the screws fixing the lower door
holders (2 pieces) respectively the
screw on the other side.
Take off the freezer door by pulling it
slightly downwards.
Unscrew the top door hinge pin of the
refrigerator then screw it back on the
other side.
Fit the freezer door on the upper door
hinge pin.
Put over the pin in the lower door
holding plate in the direction of the
arrow.
Fix the plate on the other side leaving
the position of the door unchanged.
Then screw in the one screw in the
place set free on the other side as well
as the adjustable feet (2 pieces) and
set up the box.
Put over the handles on the other side
and put the plastic covering nails
supplied in the plastic bag of this
instruction book into the holes set
free.
Put the appliance to its place, set it level and plug it into the mains socket.
In case you do not want to perform the procedures above, call the nearest
brand-mark service. Technicians will accomplish the refitting expertly for
charge.
57