Assembling The Exersaucer® - Stage 1; Important - Evenflo ExerSaucer Instructions

Warnings - continued
WARNING
READ AND FOLLOW ALL WARNINGS AND INSTRUCTIONS!
FAILURE TO DO SO COULD RESULT IN SERIOUS INJURY OR DEATH!
• DO NOT dispose of batteries in fi re, as batteries may explode or leak.
• The supply terminals are not to be short-circuited.
• DO NOT use rechargeable batteries.
• DO NOT recharge non-rechargeable batteries.
• Rechargeable batteries are to be removed from the toys before being charged.
• Rechargeable batteries are to be charged under adult supervision.
• Promptly remove exhausted batteries from the toy.
• Remove batteries before storing unit for a prolonged period of time.
• DO NOT allow unit to get wet.
• Dispose of used batteries properly.
Assembling the ExerSaucer
STAGE 1
WARNING
Stage 1 is for use by children who are at least 4 months old
AND can hold up their head and neck unassisted.
Leg
Lock Guide
1. Press Lock Guide into Leg, as shown, to create the Leg Assembly. Make sure Lock
Guide is facing in the correct direction (see illustration). Repeat for the other three
Leg Assemblies.
Make sure Lock Guide is
facing in the correct direction.
Leg
Lock Guide
2
Lock Guide
STAGE 1
2. Place end of Leg Assembly into opening on bottom of Tray. Make sure Lock
Guide lines up with slot in bottom of Tray, as shown.
3. Lift Tray until opening in Tray lines up with hole in Lock Guide. Screw Hand Lock
into hole in Lock Guide. Tighten Hand
NOT OVERTIGHTEN. Repeat steps 2 and 3 for the other three Leg Assemblies.
IMPORTANT: When inserting Hand Locks, use the same opening for each Leg
Assembly, or the ExerSaucer will not be level.
Assembling the ExerSaucer
Leg
Lock Guide
Hand Lock
Tray
Hand Lock should be finger tight. DO
Lock.
3