Care And Maintenance; Battery Safety Information - Evenflo ExerSaucer Instructions

Assembling the Art Table
Base
Base Cap
4. Turn the ExerSaucer right-side-up.
5. Place Base in opening on ExerSaucer
Tray, as shown.
6. Base Cap can be placed in Tray with
rim facing up, as shown, to create
storage area for supplies.
8
For Plastic Parts:
Wipe surface clean with cloth slightly moistened with mild soap and water.
DO NOT use abrasive cleaners or solvents. Allow to air dry.
For Wood Parts:
Wipe surface clean with cloth slightly moistened with mild soap and water.
DO NOT use abrasive cleaners or solvents. Immediately wipe dry with clean cloth.
For Seat Pad:
Machine Wash Separately, Cold Water – Delicate Cycle. NO CHLORINE BLEACH.
Tumble Dry: 10 – 15 Minutes on Low Heat – Remove Immediately.
If musical toys fail to operate, check the batteries. Note: ONLY the batteries are
replaceable. Dispose of old batteries safely.
DO NOT use this product if any parts are missing, damaged or broken.
Keep these instructions for future reference as they contain important information.
BATTERY INFORMATION:
Battery life varies with use. For longer life use only alkaline batteries.
BATTERY SAFETY INFORMATION: Batteries are small objects. Batteries must be
replaced by adults. Follow the polarity (+/-) diagram in the battery compartment.
WARNING
• DO NOT mix old and new batteries.
• DO NOT mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium)
batteries.
• Only batteries of the same or equivalent type, as recommended, are to be used.
• DO NOT dispose of batteries in fire, as batteries may explode or leak.
• The supply terminals are not to be short-circuited.
• DO NOT use rechargeable batteries.
• DO NOT recharge non-rechargeable batteries.
• Rechargeable batteries are to be removed from the toys before being charged.
• Rechargeable batteries are to be charged under adult supervision.
• Promptly remove exhausted batteries from the toy.
• Remove batteries before storing unit for a prolonged period of time.
• DO NOT allow unit to get wet.
• Dispose of used batteries properly.
Battery Replacement: To replace batteries, loosen screw and remove battery door.
Discard old batteries properly and replace with alkaline batteries. Replace door and
tighten screw.
Troubleshooting:
Toy does not turn on or does not respond.
• Make sure batteries are installed correctly.
• Make sure battery cover is correctly secured.
• Install new batteries.
Toy makes improper responses.
• Check or install new batteries.
• Power Off then Power On, to reset.

Care and Maintenance

9