Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Assembling the ExerSaucer
D
F
E
B
D
H
G
J
D
K
D
2. Place seat ring
E
upside down and locate the wheel
holders
. Snap six (6) seat wheels
holders, as shown.
3. Turn seat ring right side up.
G
Align triangle
H
on the back of the seat ring with the
triangle
on the seat pad label.
I
Snap the plastic tabs
on the pad over the pegs
on the seat ring.
I
Continue this process until all tabs are attached to
all pegs, then push the seat pad down inside the seat
ring.
K
L
4. Press assembled seat ring
down firmly onto the top
of the tray
until it snaps into place and spins freely.
L
2
F
into wheel
N
J
P
L
R
5. Locate three lower legs
tabs
then snap the lower legs onto the base. Repeat for all
M
three lower legs.
Note: Make sure the tabs on the lower legs have
locked completely into the base, as shown, by moving
the legs from side-to-side. If they are not completely
locked in place, repeat this step until they are locked
securely.
O
O
N
O
P
6. Locate the tray
Place each spring dome onto the tray over each leg
opening, as shown. Press the spring dome downward
while turning until it locks into place.
P
If you don't line up the alignment guides properly, the spring
Q
dome may come off of the tray and cause injury.
Make sure the alignment guides
P
shown.
R
7. Turn the tray over and place three large springs
R
the center of each spring dome
P
3
Assembling the ExerSaucer
M
N
O
and the base
. Align the
on the lower legs with the slots in the base,
O
L
P
and three spring domes
.
WARNING
Q
line up properly, as
R
P
into
.
Publicité
Table des Matières
