Assembling The Exersaucer; Important - Evenflo Baby Active ExerSaucer Jungle Quest Mode D'emploi

Assembling the ExerSaucer

E
C
D
E
B
A
B
C
A
A
B
2. Insert a foot C into the bottom of the pylon B, as shown.
Secure with one 8-16 X 75 mm screw D and five 8-16 X
18 mm screws E. Tighten all five screws securely but do not
E
overtighten. DO NOT USE POWER TOOLS.
IMPORTANT: The foot MUST sit completely flat in the bottom
of the pylon. If it is raised on either end, then one of the
stabilizer tubes is not installed correctly or is not fully inserted. If
this is the case, remove the stabilizer tube and reinstall until the
foot fits over it correctly.
3. Locate the other two pylons B. One at a time, turn them
upside down and completely insert the end of a stabilizer
tube A in each pylon, as shown.
Make sure the stabilizer tubes are fully inserted into the
bottom of each pylon.
4. Locate the third stabilizer tube A and insert into both pylons
B, as shown.
Make sure the stabilizer tube is fully inserted into the bottom
of each pylon.
B
2
E
C
D
E
B
C
F
C
C
G
H
Assembling the ExerSaucer
5. Insert a foot C into the bottom of each pylon B, as shown.
Secure each foot with one 8-16 X 75 mm screw D and five
8-16 X 18 mm screws E. Tighten all 12 screws securely but
E
do not overtighten. DO NOT USE POWER TOOLS.
IMPORTANT: Each foot MUST sit completely flat in the
bottom of the pylon. If it is raised on either end, then one of the
stabilizer tubes is not installed correctly or is not fully inserted.
If this is the case, remove the stabilizer tube and reinstall until
the foot fits over it correctly.
C
E
B
C
6. Turn the pylon assembly upright, as
shown.
Locate the base F and place it in the
center of the ExerSaucer.
Insert each tab on the base F into
each foot C, as shown.
F
7. Place seat ring G upside down and
I
locate the wheel holders H.
Snap four seat wheels I into wheel
holders, as shown.
3
E
D
E