Warnings; Assemble The High Chair; Adjusting The Tray - Evenflo Symmetry Mode D'emploi

ASSEMBLE THE HIGH CHAIR

1
B
CLICK!
2
D C
CLICK!
3
CLICK!
4
2
A
To protect flooring, place a protective covering (cardboard,
towel, small rug or blanket) beneath the high chair during
assembly.
Lay the high chair face down and install the front wheel tube
assembly A onto the front legs B, as shown.
Make sure the front wheel tube assembly locks onto both
front legs with an audible click on each side.
Pull on the front wheel tube assembly A to make sure it is
attached securely.
Install the back foot tube assembly C onto the back legs D, as
shown.
Make sure the back foot tube assembly locks onto both back
legs with an audible click on each side.
Pull on the back foot tube assembly C to make sure it is
attached securely.
WARNING
Care must be taken when folding or unfolding the high
chair to prevent hand or finger injury in hinge areas.
Keep one hand on the handle and one foot on the frame
while pulling up on the top of the seat until the bottom on
both sides of the high chair lock into place with an audible
click.
Press down on both tray arms to make sure the frame is
securely locked into position.
You should not see any red on the leg tubes when the seat is
securely locked into the open position.
LOCKED NOT LOCKED
5
Rotate footrest down until it clicks onto the bar beneath it.
6
E
ASSEMBLE THE HIGH CHAIR
CLICK!
Pull tabs E outward on both sides of tray. Slide tray into the
channels on each armrest of the high chair until it locks into
one of the three tray positions.
If the tray is NOT LOCKED onto the high chair, the
WARNING symbol will be visible as shown.
Pull on tray to make sure it is locked in place.
LOCKED NOT LOCKED
1

ADJUSTING THE TRAY

To adjust the tray, pull tabs outward on both sides of the tray
and slide the tray into one of the three tray positions.
Pull on tray to make sure it is locked in place.
3