Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Assembling the ExerSaucer
A
C
A
B
C
D
F
E
B
D
H
G
D
1. Turn ExerSaucer base
A
upside down and locate three
A
(3) stabilizer feet
B
. Insert one side of foot
foot bracket hole
C
and twist the foot until the other
side snaps into the opposite hole
three (3) stabilizer feet are installed.
To use stabilizer feet:
C
Flip the three (3) stabilizer feet out from beneath base to
prevent ExerSaucer from rocking.
B
2. Place seat ring
D
upside down and locate the wheel
holders
E
. Snap six (6) seat wheels
holders, as shown.
3. Turn seat ring right side up.
Align the triangle
G
on the back of the seat ring with
the triangle
H
on the seat pad label.
Snap the plastic tabs
I
on the pad over the pegs
on the seat ring.
Continue this process until all tabs are attached to
I
all pegs, then push the seat pad down inside the seat
ring.
J
2
B
into the
C
. Repeat until all
F
into wheel
N
P
J
L
4. Press assembled seat ring
of the tray
K
L
5. Locate three lower legs
tabs
then snap the lower legs onto the base. Repeat for all
three lower legs.
M
Note: Make sure the tabs on the lower legs have
locked completely into the base, as shown, by moving
the legs from side-to-side. If they are not completely
locked in place, repeat this step until they are locked
securely.
O
O
N
O
P
6. Locate the tray
Place each spring dome onto the tray over each leg
opening, as shown. Press the spring dome downward
while turning until it locks into place.
P
If you don't line up the alignment guides properly, the
spring dome may come off of the tray and cause injury.
Q
Make sure the alignment guides
as shown.
P
3
Assembling the ExerSaucer
K
down firmly onto the top
L
until it snaps into place and spins freely.
M
and the base
N
. Align the
O
on the lower legs with the slots in the base,
O
L
and three spring domes
P
.
WARNING
Q
line up properly,
Publicité
Table des Matières
