Intended Use; Predictable Misuse / Improper Handling; Residual Risks; Technical Data - hawa Powerman Kompakt Mode D'emploi

Operating instructions Powerman Kompakt

3.1 Intended Use

The Powerman Kompakt has been developed for the rapid punching of round and shaped holes in steel, stainless steel, and aluminum sheets.
Under certain conditions, also some plastics can be cut (soft plastics with sharp cutting heads). In such a case, prior trials are required.
Requirement: Based on the design using a bolt, it is required to pre-drill a hole in the work piece.
The use of the hand pump compact must follow along with the guidelines of this manual.
Each and every inappropriate usage are considered unauthorized handling and therefore outside of the manufacturer's limit of liability.
Application ranges
• Mounting plates
• Junction boxes
• Enclosures
• Cable ducts ec.

3.2 Predictable misuse / improper handling

Predictable misuse / improper handling:
• Outdoor use
• Use with blunt tooling
• Incorrectly executed repairs
• Non-intended use
• Punch, die and bolt must fit (ø of die and punch have to fit)

3.3 Residual risks

Not all risks could be avoided structurally without confinement of its intended use. The residual risks of the Hand pump Compact have been analyzed
with a risk assessment.
Possible residual risks that cannot be avoided structurally could be:
• Bruises or cutting of limbs through disregard of this instruction manual
• Bursting of a hydraulic hose
• Slipping on oil through hydraulic leak
• Cutting injuries through tools or sharp sheet metal
• Pinching of fingers during the pumping
Residual risks can be avoided by doing the following:
• Vigilant working
• Paying attention to all notes in this manual
• Following the general safety stipulations / regulations

4. Technical data

• Bolt size: 9,5 mm/ 0.37 inch
• Pressure max. 500 bar
• Oil filling: 0.19 l
• Hose length 700 mm/ 27 inch
Usable for:
• Round punches up to 60 mm
• Square punches up to 46 mm
• Rectangular punches up to 65 mm diagonale
For punching sheets of:
• Steel up to 3 mm
• Stainless steel up to 2 mm
• Aluminium up to 4 mm

5. Scope of delivery

• Pump complete with hydraulic cylinder
• Hose and torsional coupling
• 2 bolts ø 3,8" and 3/4"
• according to hand pump without punch tools
• 1 round punch each ø 12,7, ø 16,3, ø 20,4, ø 25,4, ø 32,5, ø 40,5, ø 50,5 mm
8