Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Contents
Please pay special attention to the parts of these instructions which are underlined or printed in bold or provided
with the warning sign!
Intended Purpose
The metal cable gland plates "KDP" are designed for use on cable entry cut-outs of the series 33 enclosures. They are suitable for
inserting flexible electric cables and pneumatic hoses. The KDP type is designed for indoor use in a normal industrial environment.
In the case of special operating conditions being in place, special agreements must be made with the manufacturer!
The KDP type is not designed for dynamic loads.
General Information
These instructions are an integral part of the product.
They are meant for skilled persons in industry and trade and for instructed persons to equip, set up and connect control cabinets in
compliance with the applicable standards.
Please keep them in a safe place for future reference.
We do not accept liability for any damage caused to or by users or third parties resulting from non-observance of these instructions and/
or abnormal use.
The instructions are constantly reviewed and updated if necessary (subject to technical changes) -
see https://www.haewa.com//dialogue-contact/download-centre.html.
You will find the product descriptions on our website under the respective order number. Other versions such as stainless steel enclosure
with integrated cable gland plate available upon request.
Note: Information included in the print media you have may not be up to date any more. In case of doubt, the information given on our
website shall apply.
The scope of delivery includes:
- 1 cable gland plate, pre-assembled
- 1 rubber seal
- 1 set fastening screws for attachment to enclosure
All details given apply to type KDP used on series 33 enclosures.
Safety Instructions
The instructions on foreseeable misuse and residual risks as well as the special instructions and technical data specified on pages 7 to 8
of these instructions must be observed under all circumstances to reduce danger to life and limb as much as possible.
Please take note of the standards and regulations applicable to your low-voltage switchgear and control-gear assembly.
•
For any transport as well as during unpacking and installation, ensure that the product, especially the rubber plates, are not
damaged.
•
Torque specifications must be adhered to.
•
Ensure that the ambient temperatures at the installation site do not fall below -25 °C or exceed +40 °C, that there is no coarse dirt
and excessive moisture.
•
Insert only one cable through each opening.
•
Only the opening that matches the cable diameter should be used - see Technical Data.
•
No additional weight should be applied to the cables.
•
Ensure that the cables inserted are not subjected to dynamic movement during operation.
•
Insert the cables perpendicular to the opening.
•
Secure the cables on both sides of the opening before deflecting or distributing them - see Insertion of Cables.
6
6
6
6
7
7
8
8
8
8
9
Publicité
Chapitres
Table des Matières
