Power Supply - MC Crypt MCB-1003 Notice D'emploi

Connection and control elements
(41) FX SEND output (effect output)
You can connect an external effect unit to this asymmetric mono jack socket output. This output supplies the sum
of the individual FX channel signals (depending on the settings of the respective channel FX controls).
(42) MAIN OUTPUT (L, R)
These two jack sockets supply the MASTER signal (mixed audio output signal). The jack sockets are symmetric (3
contacts). Connect the input of your amplifier to this output socket. The jack socket labelled „R" is the right output and
the jack socket labelled „L" is the left output.

Power supply

POWER SUPPLY socket
The low-voltage plug of the provided wall power supply is connected to this socket at the back of the device.
POWER on/off switch
The mixer is switched on/off using this switch at the back of the device.
• Switch pressed = mixer is switched on
• Switch not pressed = mixer is switched off
Battery compartment
The battery compartment is on the underside of the device. It is used to power the mixer and provide phantom power.
Insert three 9V (PP3) batteries into the battery compartment to operate the mixer via batteries instead of the wall
power supply.
The use of rechargeable batteries is not advisable. Due to the low capacity and voltage of rechargeable
batteries, the operating time of the mixer is significantly reduced and the phantom power required for
the condenser microphones may not be sufficient.
All manuals and user guides at all-guides.com
43