MC Crypt MCB-1003 Notice D'emploi page 37

Connection and control elements
(5) CLIP LED
The CLIP LED warns if the level on the channel is too high. The signal before the fader control triggers the CLIP LED.
The LED lights up when the signal is approx. 3dB short of clipping (distorting), thereby warning you beforehand of
any possible overloading.
(6) HI control
The HI control allows you to adjust the treble signal of a channel.
• Leftmost position = maximum attenuation
• Rightmost position = maximum gain
• Centre position = signal is not influenced by the control (neutral position)
• Setting range +/- 15dB
(7) MID control
The MID control allows you to adjust the middle signal.
• Leftmost position = maximum attenuation
• Rightmost position = maximum gain
• Centre position = signal is not influenced by the control (neutral position)
• Setting range +/- 15dB
(7a) MID frequency control
This control regulates the centre frequency for the MID control (7), i.e. the frequency at which the level control is
active.
• Setting range 150 Hz - 3.5 kHz
(8) LOW control
The LOW control allows you to adjust the bass signal of a channel.
• Leftmost position = maximum attenuation
• Rightmost position = maximum gain
• Centre position = signal is not influenced by the control (neutral position)
• Setting range +/- 15dB
All manuals and user guides at all-guides.com
37