Before Using; Checking Accessories; Preparing The Remote Control - Pioneer DV-626D Mode D'emploi

Before Using

Checking Accessories

Please confirm that the following were received with the
player.
Audio cord
Video cord
Power cord
(European model)
Remote control unit
AA/R6P batteries
Operating instructions (this manual)
Remote control operation
7m
8
En
All manuals and user guides at all-guides.com
(UK model)
0
30°
7
8
3
30°

Preparing the Remote Control

Inserting batteries into the remote
control
1
While pushing the tab on the battery
compartment cover toward the center of the
remote, pull out in the direction indicated by
the arrow.
2
Insert batteries.
Make sure to match the plus (+) and minus
(–) polarity guides on the batteries with the marks
inside the battery compartment.
3
Close the cover.
Notes
• Do not mix old and new batteries.
• When replacing batteries, use all new batteries.
• When not using the remote control for a long period of time
(over 1 month), remove the batteries to avoid possible damage
from battery corrosion. If battery leakage occurs, wipe the
battery liquid from the battery component, then insert new
batteries.
When operating the remote control, point it at the
remote sensor (Î) located on the player's front panel.
The remote control can be used up to 7 m from the
player and within a 30° angle on each side of the sensor.
Notes
• Exposing the remote sensor to direct sunlight or strong light
may cause faulty operation.
• If the CONTROL IN jack on the player's rear panel is connected
to the CONTROL OUT jack of another component, point the
remote control at the other component to operate the player.
Operation will not be possible when pointed at this player
(page 20).