Dyna-Glo RMC-55R7 Manuel De L'utilisateur page 13

Reinstall the wind cover.
S e t
Tighten 5 screws on the
cabinet
Step 25
Install the batteries in the battery case, and fill the Cartridge tank with clean, pure kerosene. Set the tank into the
heater and wait at least 60 minutes for the new wick to fully saturate with kerosene.
Remove the wick adjusting knob
once again, if it was reinstalled
before.
p 2 2
Reinstall the chimney and the
cartridge tank.
12
12
Reinstall the cabinet.
S e t p 2 3
Reinstall the wick adjusting
knob. Close the front grille.
Step 26
S e t p 2 4
Step 27