Important Safety Instructions; Grounding Instructions - Sicce Syncra HF 10.0 Manuel D'instructions

IMPORTANT SAFETY INSTRUCTIONS

WARNING -
To guard against injury, basic safety precautions should be observed,
including the following.
READ AND FOLLOW
ALL SAFETY INSTRUCTIONS
CAUTION:
Always disconnect the pump when not in use, before adding or removing
parts and before cleaning.
- Do not allow pump to run dry. Pump must be immersed in water completely.
- This pump is to be used in a circuit protected by a ground fault circuit interrupter.
WARNING:
- To reduce the risk of electric shock,
install only on a circuit protected by a Ground - Fault
Circuit - Interrupter (GFCI).
- To reduce the risk of electric shock, use only on portable
self-contained fountain no large than 5 feet in any
dimension.
- This pump has not been investigated for use in
swimming pool or marine areas.
- To avoid possible electric shock, special care should
be taken since water is employed in the use of aquarium
or pond equipment. For each of the following situations,
do not attempt repairs by yourself. Return the appliance
to an authorized service facility for service or discard the
appliance.
1) Do not operate any appliance if it has a damaged cord
or plug, or if it doesn't work properly or has been dropped
or damaged in any manner.
2) To avoid the possibility of the appliance plug or
receptacle getting wet, position aquarium stand and tank
or the fountain to one side of a wall-mounted receptacle
to prevent water from dripping onto the receptacle or plug.
A "drip-loop" (Pic. A) should be arranged by the user
for each cord connecting an aquarium appliance to a
receptacle. The "drip-loop" is the part of the cord below
the level of the receptacle or the connector if an extension
cord is used, which prevents water travelling along the
cord and coming in contact with the receptacle.
If the plug or socket does get wet, DON'T unplug the cord. Disconnect the fuse or circuit
breaker that supplies power to appliance. Then unplug and examine for presence of water
in the receptacle.
3) Close supervision is necessary when any appliance is used by near children.
4) To avoid injury, do not contact moving parts or hot parts such as heaters, reflectors,
lamp bulbs and similar.
5) Always unplug an appliance from an outlet when not in use, before putting on or taking
off parts and before cleaning. Never yank cord to pull plug from outlet. Grasp the plug and
pull to disconnect.
6) Do not use an appliance for other than intended use. The use of attachments, not
recommended or sold by the manufacturer of the appliance, may cause an unsafe
condition.
7) Do not install or store the appliances where it will be exposed to the weather or to
temperatures below freezing.
8) Make sure an appliance mounted on a tank is securely installed before operating it.
9) Read and observe all the important notices of the appliance.
10) If an extension cord is necessary, a cord with a proper rating should be used. A cord
rated for less amperes or watts than the appliance rating may overheat. Care should be
taken to arrange the cord so that it will not be tripped over or pulled.
11) This appliance has a polarized plug (one blade is wider than other). As a safety
feature, this plug will fit in a polarized outlet only one way. If the plug does not fit fully
in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Never
use with an extension cord unless plug can be fully inserted. Do no attempt to defeat this
safety feature.

GROUNDING INSTRUCTIONS

This appliance should be grounded to minimize the possibility of electric shock. This
appliance is equipped with an electric cord having an equipment gounding conductor
and a grounding type plug. The plug must be plugged into an outlet that is installed and
grounded in accordance with all appropriate codes and ordinances.
This appliance is for use on a nominal 120-volt circuit, and has a grounding plug that looks
like the plug illustrated in (II). A temporary adapter which looks like the adapter illustrated
in (III) and (IV) below may be used to connect this plug to a two-pole receptacle as shown
in (III) if a grounded outlet is not available. The temporary adapter should be used only
until a grounded outlet is not available. The temporary adapter should be used only until
a grounded outlet can be installed by a qualified electrician. The green-colored rigid ear
(lug, and the like) extending from the adapter must be fastened to a permanent ground
such as a grounded outlet box.
SAVE THESE INSTRUCTIONS