PMA KS 30 Mode D'emploi page 8

Re-configurations
+
+
+ With re-configuration of the input type, all range-dependent parameters
must be matched to the new measuring range!
Structure of configuration word 2 ( Con2):
not used
Exit from the configuration level
Unit at configuration level
+
+
Functions and parameters for programmer, ramp and gradient
Set-point W Proc.val. X Start behaviour
W < SP2 X < SP2
W < SP2 X > SP2 Start at SP2
W > SP2 X < SP2 Start at SP2
W > SP2 X > SP2
Con2
Programmer
ramp function *
Programmer
* also gradient function
with 9404 407 6....
The effective set-point
runs from X to SP2
with positive ramp
The effective set-point
runs from X to SP2
with negative rampe
I
M
Output
switching
Instrument is initialized.
Behaviour with mains recovery
re-started with key M
(for behaviour Ä table opposite).
automatic re-start of ramp
(for behaviour Ä table opposite).
Programmer and ramp function are not
available.
W SP2 0
W SP2
D
Heating current monitoring Ü
Actuator interruption/
Actuator short circuit
Overcurrent in load
ÜExplanation Ä previous page
Unit is at
blinks; the program can be
----