Ribimex Ribiland 97cc Manuel D'instructions Et D'utilisation page 30

4.6- Stopping the engine
4.6.1- In normal use
Please withdraw the throttle switch and leave the engine running for 1~2 minutes at low speed to
cool the engine.
1. Move the throttle lever (16) all the way up.
Fig.18
3. Turn the fuel valve (a) to OFF position.
Fig.20
4.6.2- In an emergency
In case of emergency: Please stop the engine immediately
To stop the engine in an emergency, turn the engine switch (5) to the OFF position.
4.7- Adjusting the idle speed of the engine
The idle speed of the engine was adjusted in the factory
The user should not attempt to adjust it to avoid any danger.
After the throttle lead is completely released, if the idling speed of the engine is too low or too
high, please contact the qualified service person to adjust it.
4.8- After use
Remove the hoses, drain off the water inside the pump and remove the water and impurity
substances inside the hoses. Store it in the specified place.
Important! In cold winter, please be sure to drain off the water inside the pump after use. As the
temperature outdoors is below zero centigrade, the water inside the pump will be frozen, which may
damage the pump.
2. Turn the engine switch (5) to OFF position.
Fig.19
Page 30 of 54