Ribimex Ribiland 97cc Manuel D'instructions Et D'utilisation page 29

5. Operate the recoil starter (6).
Pull the starter grip rope lightly until you feel
a resistance, then pull briskly until engine
starts.
Return the starter rope gently.
Repeat operation if necessary, and until
engine starts.
Fig.15
Tips: Hold pump (one hand on handle and one foot
on base)
Do not pull starter grip rope over its full length.
Return starter rope gently so as not to damage the
recoil starter.
Remarks:
- Hold the engine firmly with your left hand, then pull out the starter handle with your right hand,
gently in the beginning until you feel the resistance, and then pull it out rapidly.
- Please do not pull out all the starting rope and do not release it rapidly. Doing so will damage
and/or breakdown the starter.
- If you restart the engine after it is stopped, please set the throttle to the "OFF" position.
Troubleshooting
- If after three or four attempts, the engine still does not start, excessive fuel may have drowned
the spark plug. You can try to start without the choke, or disassemble the spark plug to dry the
electrode which may be submerged in fuel.
- If the electrode is dry upon dismantling (lack of gasoline), close the fuel cock, and then check
the sediment cup located under the carburetor.
Remove impurities and then check the gasoline flow by opening the fuel cock and assemble the
cup, paying attention to the condition of the seal
After the engine is started, turn on the choke throttle gradually and withdraw the throttle switch.
Leave the engine running for 1-2 minutes at low speed to heat the engine.
6. As the engine warms up, gradually open the choke
(14)
7. Set the throttle lever (16) at the desired speed.
Fig.16
Fig.17
Page 29 of 54