Monacor ATS-10TM Mode D'emploi page 9

8) In case of poor or disturbed reception,
check if
a) the reception can be improved by using
a different transmission channel
b) the batteries of the units are discharged
(LED on the unit permanently shows
red) .
c) the distance between the transmitter
and the receiver is too long .
d) the reception is disturbed by objects in
the transmission path .
e) the reception can be improved by turn­
ing the antenna of the transmitter .
9) To switch off the transmitter, set the switch
(7) to the right stop to OFF: After switch­
ing off, the LED BATT . LOW (8) turns from
green to red before it is extinguished .
Note concerning multichannel operation:
The number of channels to be used in parallel
depends on the conditions at the place of appli­
cation (e . g . on interference due to other wireless
systems or high­frequency sources such as fluores­
cent lamps) . In ideal conditions, up to four channels
can be operated at the same time without mutual
interference . Two examples of a suitable channel
selection for four wireless transmission paths:
Example 1:
channel 0 – channel 2 – channel 5 – channel B
Example 2:
channel 5 – channel 8 – channel E – channel F
6 Specifications
Type of unit: . . . . . . 16­channel PLL trans­
Radio frequency
range: . . . . . . . . . . 863 – 865 MHz
Transmitting power: ≤ 10 mW (EIRP)
Range: . . . . . . . . . . approx . 50 m
Ambient
temperature: . . . . . 0 – 40 °C
Power supply: . . . . 2 × rechargeable
Dimensions
: . . . . . . .65 × 92 × 25 mm
Weight: . . . . . . . . . 78 g (without batteries)
Subject to technical modification .
All rights reserved by MONACOR
GmbH & Co. KG. No part of this instruction manual
may be reproduced in any form or by any means for
any commercial use.
mitter for wireless audio
transmission
1 .2 V NiMH battery or
2 × 1 .5 V battery,
size AA
(W × H × D)
INTERNATIONAL
®
9