Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
G
B
12 - Insert lower cover into notch and fasten with screws (fig. 17).
13 - Insert upper cover and fasten with screws.
14 - Check functioning of TOUCH Wi-Fi as described under the paragraph of "CHECK PROPER
FUNCTIONING".
IDENTIFICATION
Each TOUCH Wi-Fi is supplied with microswitches in the OFF position to prevent batteries from
becoming discharged when not in use (if connected).
Each TOUCH Wi-Fi must be ABSOLUTELY unequivocally identified by putting only one of the six
microswitches in the ON position (SW2).
Only one of the six microswitches must be in the ON position and the identification must be
different for each TOUCH Wi-Fi.
Note: IDENTIFY TOUCH Wi-Fi CONTAINERS BY APPLYING NUMBERED ADHESIVE LABEL (SUPPLIED)
ON OUTSIDE OF EACH CONTAINER.
Identification of containers serves to rapidly replace dead batteries in TOUCH Wi-Fi indicated
by EDGE LED on MASTER Wi-Fi card.
EXAMPLE OF IDENTIFICATION OF A TOUCH Wi-Fi STRIP ON A
MASTER Wi-Fi
6
5
4
3
2
ON
1
MASTER Wi-Fi
MEMORIZATION
After identifying the TOUCH Wi-Fi, put the microswitches corresponding to the MASTER Wi-Fi in
the ON position and memorize the codes of the TOUCH Wi-Fi:
- Press the PROG RX key located on the MASTER Wi-Fi=> the EDGE PHOT 1 LED will flash red for
one minute (the time needed to execute memorization).
- Press the PROG TX key on the TOUCH Wi-Fi with DIP 1 set to ON => on the MASTER Wi-Fi the
EDGE PHOT 1 LED flashing red will become green and a buzzer will signal that memorization of
the TOUCH Wi-Fi is correct, after which the EDGE PHOT 2 LED immediately starts flashing red
for one minute (time needed to execute memorization) l.
- If other TOUCH Wi-Fi are not memorized, let one minute pass and the EDGE PHOT 2 LED turns
off; or press the PROG. RX key four times to end the memorization procedure => all EDGE
PHOT LEDs must be off.
EXAMPLE OF IDENTIFICATION OF 3 TOUCH Wi-Fi STRIPS
ON A MASTER Wi-Fi
6
5
4
3
2
1
TOUCH Wi-Fi 1
MASTER Wi-Fi
1
2
1
2
6
5
4
3
2
ON
1
TOUCH Wi-Fi 1
PROG RX
18
Insertion
OFF
3
4
5
6
ON
3
4
5
6
6
6
5
5
4
4
3
3
2
2
1
1
TOUCH Wi-Fi 2
TOUCH Wi-Fi 3
LED EDGE PHOT 1
12/24V ac/dc
17
6
5
4
3
2
1
Publicité
Table des Matières
