Dremel Micro 8050 Consignes De Sécurité/D'utilisation page 20

DM 2610031565 05-14-v8_8050 5/13/14 11:45 AM Page 20
Use only Dremel
W RNING
designed for this tool and may lead to personal injury or property damage.
The number and variety of accessories for the
Rotary Tool are almost limitless. There is a
category suited to almost any job you might
have to do — and a variety of sizes and shapes
within each category which enables you to get
the perfect accessory for every need.
COLLETS
If you expect to use a variety of accessories,
we recommend that in the beginning you
purchase a complete set of four collets. Store
these so that you will have the proper size of
collet for any accessory or drill bit you want to
use. Currently, the 1/8", 3/32",1/32" and
1/16" collets accommodate all of the avail-
able Dremel accessories. 1/8" collets are
included in most rotary tool kits.
MANDRELS
A mandrel is a shank with a threaded or screw
head, which are required when you use
polishing accessories, cutting wheels, sanding
discs, and polishing points. The reason
mandrels are used is that sanding discs,
cutting wheels and similar accessories must be
replaced frequently. The mandrel is a per-
manent shank, allowing you to replace only the
worn head when necessary, thus saving the
expense of replacing the shaft each time.
Screw Mandrel No 401
This is a screw mandrel used with the felt
polishing tip and felt polishing wheels. 1/8"
shank.
Small Screw Mandrel No 402
This is a mandrel with a small screw at its tip,
and is used with emery and fiberglass cutting
wheels, sanding discs and polishing wheels.
1/8" shank.
Dremel Accessories
®
, high-performance accessories. Other accessories are not
The Dremel EZ Lock makes accessory
changes easy as PULL - TWIST - RELEASE.
The one-piece mandrel design simplifies the
process of changing cutting wheels, buffs and
detail abrasive brushes (EZ Lock compatible
accessories).
EZ Drum™ Mandrel No EZ407SA
The Dremel EZ Drum makes accessory
changes easy as PULL - INSERT - PRESS
DOWN. The one-piece mandrel design
simplifies the process of changing sanding
bands.
Available in many shapes, high speed cutters
are used in carving, cutting and slotting in
wood, plastics and soft metals such as
aluminum, copper and brass. These are the
accessories to use for freehand routing or
carving in wood or plastic, and for precision
cutting. Made of high quality steel. 1/8" shank.
These are tough, long-lived cutters for use on
hardened steel, fired ceramics and other very
hard materials. They can be used for
engraving on tools and garden equipment. 1/8"
shanks.
This group has a wide variety of sizes and
shapes, and are made for intricate work on
ceramics (greenware), wood carvings, jewelry
and scrimshaw. They often are used in making
complicated printed circuit boards. They
should not be used on steel and other very
hard materials but are excellent on wood,
plastic and soft metals. 1/8" shank.
20
EZ Lock Mandrel No 402
High Speed Cutters
Tungsten Carbide Cutters
Engraving Cutters