Dremel Micro 8050 Consignes De Sécurité/D'utilisation page 19

DM 2610031565 05-14-v8_8050 5/13/14 11:45 AM Page 19
NO USER SERVICEABLE
W RNING
PARTS INSIDE. Preventive
maintenance performed by unauthorized
personnel may result in misplacing of
internal wires and components which
could cause serious hazard. We recom-
mend that all tool service be performed by a
Dremel Service Center. SERVICEMEN:
Disconnect tool and/or charger from power
source before servicing.
BATTERIES
Be alert for batteries that are nearing their
end of life. If you notice decreased tool
performance or significantly shorter running
time between charges then it is time to
replace the battery. Failure to do so can
cause the tool to operate improperly or
damage the charger.
D.C. MOTORS
The motor in your tool has been engineered
for many hours of dependable service. To
maintain peak efficiency of the motor, we
recommend it be examined every six months.
Only a genuine Dremel replacement motor
specially designed for your tool should be
used.
Maintenance
Service Cleaning
To avoid accidents, always
W RNING
be sure the tool is turned
"OFF" before cleaning. The tool may be
cleaned most effectively with compressed dry
air. Always wear safety goggles when
cleaning tools with compressed air.
Ventilation openings and switch levers must
be kept clean and free of foreign matter. Do
not attempt to clean by inserting pointed
objects through opening.
Certain cleaning agents
C UTION
and
plastic parts. Some of these are: gasoline,
carbon tetrachloride, chlorinated cleaning
solvents, ammonia and household detergents
that contain ammonia.
19
solvents damage