Sawing With Parallel Guide Fence; Setting For Mitre Cuts; Service And Maintenance; Storage - Mafell KSS 400 Notice Originale

5.7 Sawing with parallel guide fence

(Optional accessories)
When making parallel cuts, the parallel guide fence 4
(Fig. 2) serves to saw parallel to an already existing
edge. The guide fence can be attached to the left or
right of the machine. The cutting range on the right-
hand side amounts to approx. 155 mm (6 1/8 in.) and
on the left-hand side to approx. 280 mm (11 1/32 in.).

Once you have unfastened the wing screws you
can adjust the cutting width 9 (Fig. 2) by moving
the guide fence accordingly and afterwards
retightening the wing screws.
In addition, by simply turning it around (guide face for
the workpiece edge points upwards), the parallel stop
can also be used as double support to improve
guidance of the machine. Now the machine can be
guided along a lath that is fastened on the workpiece.

5.8 Setting for mitre cuts


Release the limit stop 21 (Fig. 3) and adjust the
angle according to the scale on the guide rail.

Retighten the limit stop.

Apply the machine to the workpiece to be
processed with the two stop bolts on the bottom
7

Troubleshooting

Some of the most frequent defects and their causes are listed in the following chart. In case of other defects,
contact your dealer or the MAFELL customer service.
Defect
Machine cannot be switched on
Machine stops while cutting is in
process
Danger
Determining the causes for existing defects and eliminating these always
requires increased attention and caution. Pull the mains plug beforehand!
Cause
No mains voltage
Mains fuse defective
Carbon brushes worn
Mains failure
Machine overloaded
-22-
side of the guide rail and execute the cut by
pushing the machine forward.

After the cut, return the saw to its starting
position by retracting it.
6

Service and maintenance

Danger
Pull the power plug during all
service work.
MAFELL machines are designed to be low in
maintenance.
The ball bearings used are greased for life. When the
machine has been in operation for a longer period of
time, we recommend to hand the machine in at an
authorised MAFELL customer service shop for
inspection.
Only use our special grease, order No. 049040 (1 kg
tin) for all greasing points.

6.1 Storage

If the machine is not used for a longer period of time,
it has to be carefully cleaned. Spray bright metal parts
with a rust inhibitor.
Elimination
Check power supply
Replace fuse
Take the machine to a MAFELL
customer service shop
Check mains back-up fuses
Reduce feed speed