Korg ZERO4 Manuel D'utilisation page 8

24. GATE PLAY button
This records/plays the loop sampler. If no
sample is being held, this button will initiate
recording. If a sample is being held, this button
will initiate gate playback.
25. MASTER FX TYPE knob
This selects the master effect type.
26. X knob
This adjusts a parameter of the master effect.
The result will depend on the master effect type.
27. Y knob
This adjusts a parameter of the master effect.
The result will depend on the master effect type.
28. MASTER FX & SAMPLE MIX fader
This adjusts the mix balance between the loop
sampler / master effect bus input (dry) sound,
and the output (wet) sound.
29. MASTER FX & SAMPLE CUE button
If you press this button to make the LED light,
the audio of the loop sampler / master effect
bus will be sent to the CUE bus.
30. Master level meter
This level meter indicates the level of the master
out. If clipping occurs, the red LED will light;
adjust the master out level so that this indicator
does not light.
31. BOOTH volume knob
Adjusts the output level from the BOOTH OUT jacks. This will output
the same sound as the MASTER OUT jacks.
32. MASTER volume knob
Adjusts the output level from the MASTER OUT jacks.
33. BPM display
This indicates the currently-specified BPM value.
8
20
21
22
23 24
25
26 27
28
29
34. BPM CH SELECT switch
This selects the source from which BPM
will be detected when the AUTO BPM
function is on.
35. TIME/AUTO push knob
This specifies the BPM used for BPM sync
effects and as the MIDI clock master.
You can switch the AUTO BPM function
on/off by pressing the push knob.
36. TAP button
The timing interval at which you press this
button is used to set the BPM value or as a
guide for auto BPM detection.
If you've selected an effect that uses the
LFO, this button will reset the LFO.
37. AUTO BPM indicator
This will light if the auto BPM counter is
on.
38. SPLIT button
This switches the Split function on/off for the headphone monitor.
LED lit: The CUE audio will be output from headphone L, and the
master audio will be output from headphone R. In this case, the L side
of the master level meter will indicate the CUE level, and the R side
will indicate the master level.
LED dark: The CUE and MASTER audio will be output at the balance
adjusted by the MONITOR BAL knob.
39. MONITOR BAL knob
If this is turned toward CUE, the headphones will monitor the CUE bus.
If this is turned toward MASTER, the headphones will monitor the MAS-
TER OUT jacks. This knob does nothing if the Split function is on.
40. MONITOR LEVEL knob
Adjusts the headphone volume.
32
31
33
34
35 36
37
38
39
40