RS Pro EZM-4430 Mode D'emploi page 10

5:
Automatic Reset-3:
count value reaches the
Set value,Output position
is changed.Count value
becomes zero.(For 0->P)
Counting restarts on "0" value,
but Set Value is showen on the
Process value screen.
Output position becomes the old
and the Real count value
can be seen at the end of
output pulse time.
6:
Automatic Reset-4:
count value reaches the
Set value,Output position
is changed.Count value is
automatically reset and
counting will continue ( for
0->P) and Output position
changes the old
position at the end of the
output pulse time.
7:
Automatic Reset-5:Process
counts,until manuel reset
happens.Output pulse time
does not take into considera
tion.This function can be
prefered on systems that,
upcounts or downcounts at
the same time.
:Output Run Type (Default=0)
Normally De-energised.
Normally Energised.
:Output Pulse Time (Default=0.00)
It determines how long Output will be active.It can be adjusted from
00.00 to 99.99 seconds. If it is 00.00 second ,then it operates
indefinitely.
When
When
10