Check List For The Installation Of The Webasto Charging Station - Webasto Pure Notice De Montage

Descrip- Data
tion
Max. char- 11 kW or 22 kW (depending on
ging power factory configuration)
[kW]
Operating -25 to +55 (without direct solar ra-
temperature diation)
range [°C]
Storage -25 to +80
temperature
range [°C]
Display LED element
Lock Key-operated switch set to start
charging
Altitude [m] max. 2000 (above sea level)
Permissible 5 up to 95 Non-condensing
relative hu-
midity [%]
Weight [kg] 11 kW: 4.6
22 kW: 5.6
Dimensions See figures in "Assembly on page
[mm] 22"
17 Check list for the
installation of the
Webasto charging
station
Charging sta- Webasto Pure
tion
5110159D Webasto Pure
Charging 11 kW 22 kW
power
Serial number
Material num-
ber
General :
Installation, electrical connection and initial
operation of the charging station must be
carried out by an electrician.
Local conditions:
The charging station has not been installed
in an explosion sensitive area (EXzone).
The charging station has been installed in a
location where falling objects cannot dam-
age the charging station.
The charging station should not be exposed
to direct rain or sunlight in order to prevent
damage.
The location of the charging station should
be selected such that vehicles cannot inad-
vertently collide with it.
The legal requirements for electrical installa-
tions, fire protection, safety regulations and
escape routes have been met.
The charging cable does not block any pas-
sageways.
The charging cable and coupling has been
protected against coming into contact with
external heat sources, water, dirt and chem-
icals.
Local conditions:
The charging cable and coupling has been
protected against being driven over, trapped
or any other mechanical hazards.
The customer/user was informed how the
Webasto Pure voltage is switched off with
the installation-side protective devices.
Charging station requirements:
The cable support sleeves for the power
cable and data cable (for live only) have been
fitted during installation.
The kink protection for the charging cable
has been screwed onto the charging station
and the rubber seal has been fitted correctly
into the kink protection.
The suitable charging cable (11 kW or 22
kW) has been installed in the charging sta-
tion (as per type label) during installation.
The strain relief clamp that ensures the char-
ging cable has strain relief has been fitted.
The specified torques have been observed.
The charging cable has been connected as
per the instructions in the operating instruc-
tions.
Tools and installation remnants have been
removed from the charging station before
closing the cover.
The serial number of the charging station
has been registered on the online portal:
https://webasto-charging.com
Customer/client:
Place: :
Signature
EN
23