Safety Information For Electrical Connection; Safety Information For Initial Start-Up; Unit Description - Webasto Pure Notice De Montage

Do not install the charging station in
–
areas subject to ammonia or air con-
taining ammonia.
Do not install the charging station in
–
a location where falling objects (e.g.
extension reel or tyres) can damage
the charging station.
The charging station is designed for
–
use indoors, e.g. garages as well as
for use in protected outdoor areas,
e.g. carports. Do not install the char-
ging station in the vicinity of water
jets, e.g. car wash installations, high
pressure cleaners or garden hoses.
The charging station shall not be ex-
–
posed to direct rain to prevent dam-
age due to freezing, hail or similar.
Protect the charging station from dir-
–
ect sunlight. The charging current
may be reduced at high temperatures
or charging may be disabled com-
pletely.
The installation location of the char-
–
ging station should be selected such
that vehicles cannot inadvertently col-
lide with it. Protective measures must
be implemented if the possibility of
damage cannot be ruled out.
5110159D Webasto Pure
Do not place the charging station into
–
operation if it is damaged during in-
stallation. A replacement will be re-
quired.
2.4 Safety information for
electrical connection
Comply with the nationally applicable
–
requirements pertaining to electrical
installations, fire protection, safety
regulations and escape routes at the
intended installation location. Ob-
serve the applicable national installa-
tion regulations.
Each charging station must be protec-
–
ted with its own line circuit breaker
and residual current circuit breaker.
See "Requirements at the installation
location on page 17".
Make sure that the electrical connec-
–
tions are de-energised before con-
necting the charging station to the
power supply.
Do not connect a vehicle during initial
–
start-up of the charger.
Make sure that the correct supply
–
cable is used for the power connec-
tion.
Do not leave the charging station un-
–
attended with the cover open.
Do not install the charging station
–
without the mounting frame.
Change DIP-switch settings only with
–
the power off.
Register with the power supply com-
–
pany as required.
2.5 Safety information for
initial start-up
Initial start-up of the charging station
–
must be carried out only by an electri-
cian.
Prior to initial start-up, the electrician
–
must check that the charging station
has been connected correctly.
Before starting-up the charging sta-
–
tion, check the charging cable, char-
ging coupling and the charging sta-
tion for visible damage. The charging
station must not be started up if it is
damaged or if the charging cable/
charging coupling is damaged.
3

Unit description

These operating and installation instructions
describe the Webasto Pure. You can find a
detailed product description on the type la-
bel of your Webasto Pure
See also Fig. 1
EN
13