General Safety Information; Safety Information For Installation - Webasto Pure Notice De Montage

NOTE
EN
It is possible that the signalling in the
vehicle differs from that described
here. Always read the operating in-
structions of the respective vehicle
manufacturer and always observe
these.
2.2

General safety information

Hazardous voltages are present within
–
the casing.
The charging station does not have its
–
own main ON/OFF switch. The pro-
tective devices installed in the power
supply system are therefore also used
to disconnect the power supply.
Check charging station for visual dam-
–
age before use. Do not use the char-
ging station if damaged.
Installation, electrical connection and
–
initial operation of the charging sta-
tion must only be carried out by an
electrician.
Do not remove the cover of the in-
–
stallation area whilst in operation.
Do not remove markings, warning
–
symbols and the type label from the
charging station.
The charging cable must only be re-
–
placed by an electrician in accordance
with the installation instructions.
12
It is strictly prohibited to connect
–
other equipment/devices to the char-
ging station.
When not in use, store the charging
–
cable in the designated holder and
lock the charging coupling in the
charging station. Loosely wind the
charging cable around the charger
casing so that it does not touch the
ground.
Make sure that the charging cable
–
and coupling cannot be driven over,
trapped and are protected from any
other hazards.
Immediately notify Webasto Customer
–
Service if the charging station, char-
ging cable or the charging coupling
are damaged. Do not continue using
the charging station.
Prevent the charging cable and coup-
–
ling from coming in contact with ex-
ternal heat sources, water, dirt and
chemicals.
Do not attach extension cables or ad-
–
apters to the charging cable.
Remove the charging cable by pulling
–
on the charging coupling only.
Never clean the charging station with
–
a high-pressure cleaner or similar
device.
Switch off the power supply before
–
cleaning the charging sockets.
When using the charging cable,
–
please ensure that the maximum per-
mitted force of 39 N (for 11 kW) and
48 N (for 22 kW) is not exceeded.
Ensure only persons who have read
–
these operating instructions have ac-
cess to the charging station.
2.3 Safety information for
installation
Installation and connection of the
–
charging station must only be carried
out by an electrician.
Only use the supplied installation ma-
–
terial.
The Webasto Pure safety concept is
–
based on a power supply system that
is earthed at all times. The electrician
must ensure this requirement during
installation.
The charging station is suitable for use
–
in areas without access restrictions.
Do not install the charging station in
–
an explosion sensitive area (EX zone).
Install the charging station in such a
–
way that the charging cable does not
block any passageways.
5110159D Webasto Pure