Touch Control Switch (Reset); Key-Operated Switch; Start Charging; Stop Charging - Webasto Pure Notice De Montage

Fault Description
list
There is a fault in the power connection
to the charging station, phase monitor-
ing is active, charging station charges
with reduced power.
u Checking of the rotary field by
an authorised electrician.
F5 LED flashes red for 1 s at 2 s intervals, a
signal sounds for 28 s and then for 2 s
every 10 minutes:
There is a fault in the vehicle.
u Re-connect the vehicle
Fault indicators and troubleshooting
Table 3:
NOTE
If the warning persists, contact
Webasto Charging Hotline under
00800-24274464.
Fault Description
list
F6 LED flashes red for 0.5 s at 0.5 s and
3 s intervals:
the supply voltage is outside the valid
range of 180 V to 270 V.
u Checking by an authorised elec-
trician.
Fault indicators and troubleshooting
Table 4:
5110159D Webasto Pure
4.3 Touch control switch
(reset)
NOTE
Do not press but only touch the
touch control switch, do not wear
gloves when operating.
The touch control switch is used to acknow-
ledge faults.
Action Description
Starts a system self-test
u Touch and hold
and resets failures.
the switch for at
After the fault has been
least 10 s.
rectified, the charging
station switches back
to "standby" mode.
4.4

Key-operated switch

The key-operated switch is used for author-
isation purposes and can be turned through
90°. Turn clockwise to unlock the charging
station. Turn anticlockwise to lock the char-
ging station.
See also Fig. 4
NOTE
The key can be removed in both pos-
itions.
4.5

Start charging

NOTE
Always take into account the vehicle
requirements before charging a
vehicle.
NOTE
Park the vehicle for charging such as
to avoid strain in the charging cable.
See also Fig. 5
Action Description
Charging station performs system
u Connect
and connection tests.
the char-
LED: is blue, turns red for about 2
ging
seconds after connecting to the
coupling
vehicle and then either turns
to the
green (vehicle is charging) or
vehicle.
flashes blue (vehicle not yet ready
for charging).
4.6

Stop charging

4.6.1 The vehicle has stopped the
charging cycle automatically
Action
u Unlock the car if necessary.
u Unplug the charging coup-
ling from the vehicle.
u Lock charging coupling in
the holder of the charging
station.
EN
Descrip-
tion
LED flashes
blue at 1
second in-
tervals.
Vehicle con-
nected, not
charging.
15