Quick Reference - SELFSAT SNIPE PRO Manuel Utilisateur

5. Special function 2 : ERROR MESSAGE
Error message LED will be illuminated and the error message detail will be shown on LCD display, this will
detail if there is a problem with main unit.
i. HOME POSITION error
If antenna does not come back to HOME position within the allowed time or the system does not
recognise HOME position despite the antenna being back at HOME position (The Limit sensor is
faulty).
ii. TUNNER error
If there is no response when searching the satellite due to a faulty tuner or its settings.
iii. MOVEMENT error
If the PRO MAX cannot move to correct position for some reason.
iv. COMMUNICATION error
If connection is lost between the unit and controller that lasts longer than 5 seconds.
6. Special function 3 : TEST mode
TEST mode can be initialised when either an error message is shown or the antenna is at HOME position.
a. Press MODE once to enter TEST mode and press OK.
b. Go to the available functions on LCD using the arrow buttons and press OK to select.
c. To exit, press MODE and unit will return to previous status.

3-3. Quick reference

1. Press POWER to turn on the unit and select a satellite using arrow buttons and press OK.
2. Wait until "SAT FOUND" is displayed on LCD and NID check (second LED on the left side)
becomes solid.
3. Now, the selected satellite has been locked and the TV channels will be shown on TV
WARNING
When user physically moves the unit, the unit must be returned to HOME
position to prevent damage.
NOTE
The unit will be automatically folded back to HOME position if vehicle
moves faster than 25km/h when the unit is powered.
ENGLISH - 9