Quick Reference - SELFSAT SNIPE DOME Manuel Utilisateur

3-3. Quick Reference

Classification
Operating
(Searching the satellite)
10
1. Switch on with the "Power switch" button on the top of the controller.
2. Upon power on, all LED will flash twice.
3. Wait until "Stand by State" light & one "Satellite LED" light, which you set
previously or the first satellite in the controller, remain solid on.
4. Select the desired satellite using the "UP/DOWN" buttons, then press the
"OK" button to select.
5. The satellite LED light will start to flash, wait until it stays solid on.
6. When the satellite LED light stays solid on, the selected satellite has been
located and a signal can be seen on the satellite TV.
Description