Quick Reference - SELFSAT SNIPE PRO Manuel De L'utilisateur

3-3. Quick Reference

Classification
Operating
(Searching the satellite)
10
1. Switch on with the "Power switch" button on the top of the controller.
2. Upon power on, all LED will flash twice.
3. Wait until "HOME Status" light & one "Satellite LED" light, which you set
previously or the first satellite in the controller (Turksat), remain solid on.
4. Select the desired satellite using the "CCW / CW" buttons, then press the
"OK" button to select.
5. IF the satellite LED light starts flashing, please wait for a while until it
turns to keep the LED on steadily.
6. When the satellite LED light stays on, the selceted satellite has been
located and a signal can be seen on the satellite TV.
WARNING
When you move SNIPE PRO, the flat dish of the antenna must be at the
Home position.
NOTE
SNIPE PRO will be automatically folded back to HOME position if the
vehicle moves faster than 10km/h, when the reception of GPS is stable.
Description