Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
D. Fix the antenna main unit with 4 pcs of nuts using spanner
D-1
Parts required, spanner and four(4) Nut
D-3
Fit the nuts to each of the four bolts and tighten
firmly with spanner
E. Cable holder installation 1
E-1
Place cable holder around 30CM from the rear centre of the antenna. Apply friction tape 5mm from
the outside of the holder
E-2
Drill a 20mm hole (or larger) in the centre of the
tape marking
D-2
Place the antenna on bolts on the mounting
plate. Put 4 Nuts on each bolts.
D-4
Make sure you check and four (4) nuts are
tightened
E-3
Make sure that hole size is big enough to insert
all cables together by one and one
ENGLISH - 18
Publicité
Chapitres
Table des Matières
