Functional Description; Get Ready To Use - SELFSAT SNIPE PRO Manuel Utilisateur

3-2. Functional description

HOME LED
Communication LED
NID check LED
Error message LED
HOME , MODE , SET , TUNE button

1. Get ready to use

a. When the all cable connections are completed, press POWER to turn the unit on.
b. HOME LED will be solid this means the antenna is ready to go.
If the antenna did not go back to HOME position, HOME LED will continue to flash while antenna
comes back to HOME. When the unit is ready, the default satellite "ASTRA1" or the last selected
satellite will be shown on LCD screen of the controller.
NOTE
HOME position is when the antenna completely folded down and facing forward.
c. Communication LED will be solid when the unit is turned on.
(This light means antenna unit is communicating with controller correctly.)
d. GPS LED flashes while searching for the current location. When GPS position is confirmed the LED
will become solid.
e. Waiting until both HOME & GPS LED's are solid is recommended as this will allow the unit to find the
selected satellite faster with more precise alignment accuracy.
f. If the searching operation starts before GPS becomes solid GPS LED will continue to flash even when
the satellite is already locked. In this case, the unit may readjust skew once its current location is
confirmed.
ENGLISH - 7
GPS LED
POWER , Arrows , OK button