SELFSAT SNIPE PRO Manuel Utilisateur page 20

F. Cable holder installation 2
F-1
controller cable and of receiver cables, cable holder and gland for installation
F-2
Put the cable inside the Cable holder as above picture.
F-3
Place the assemble cable holder inside the tape
markings. Drill three(3) 2mm holes
F-5
Apply silicone around cable holder and on the
top of the screws for waterproof
F-4
Fix cable holder on the vehicle roof with
three(3) of M4 x 20 screws at drill holes made
F-6
Connect cables to relative ports. Remove
friction tape then tidy silicone before dry
ENGLISH - 19