CLEANING INSTRUCTIONS
!
WARNING!!
from the power source. It is important to read & fully understand all of the instructions
& safeguard prior to use of the Dehydrator.
1. Clean the Trays and inside the Cabinet before using the Dehydrator for the
first time and after each use.
2. Turn the Power Switch OFF "O". Disconnect the Power Cord from the
electrical outlet.
3. Allow the Dehydrator to completely cool before cleaning.
4. Remove the Trays from the Cabinet.
5. Wipe the Cabinet clean, inside and out, with damp sponge or soft cloth.
Be careful not to splash water onto the heating element (located behind the
screening and fan in the back of the Cabinet) while cleaning the inside of the
Cabinet. Water could damage the heating element and the increases the risk
of electric shock. DO NOT immerse the Dehydrator in water.
6. Clean the Trays with warm, soapy water. Rinse with clear water and dry
immediately.
GROUNDING INSTRUCTIONS
GROUNDING
This appliance must be grounded while in use
to protect the operator from electrical shock.
The appliance is equipped with a 3-conductor
cord and a 3-prong grounding type plug to fit
the proper grounding-type receptacle. The
appliance has a plug that looks like Figure
A. An adapter, Figure B, should be used
for connecting Figure A plugs to two-prong
receptacles. The grounding tab which extends
from the adapter must be connected to a
permanent ground such as a properly grounded
outlet box as shown in Figure C using a metal
screw.
EXTENSION CORDS
Use only 3-wire extension cords which have
3-prong grounding-type plugs and a 3-pole
cord connector that accepts the plug from the
appliance.
an electrical rating not less than the rating of
the appliance. Do not use damaged extension
cords. Examine extension cord before using and
replace if damaged. Do not abuse extension
cord and do not yank on any cord to disconnect.
Keep cord away from heat and sharp edges.
6
Before cleaning or servicing the Dehydrator, make sure it is unplugged
Use only extension cords having
Grounding
Prong
Circuit
Grounding
Conductor
Metal
Grounding
Screw
Cover of
Grounded
Outlet Box
Grounding
Means
AA2220
FIGURE A
FIGURE B
FIGURE C