Beyerdynamic MCS 20 Notice D'utilisation page 43

MCS 20 – MCS 223 Microphone Unit
How to load the configuration
• The procedure for loading a setup is almost the same as when saving a setup. Please note in step 4 you have to
press the "Prior" button
• Step 1 – How to activate the programming mode
Press the "Voice" button and the "Requ" button
button first), until a function number is displayed
indicated by a flashing full stop after the left number.
full stop after the left
number is flashing
• Step 2 – How to select function 00 (setup menu)
Press the [-] "Limit" button
• Step 3 – How to select the setup number
Press one of the "Vol" buttons
right number is flashing.
• Step 4 – How to load the setup
Press the "Prior" button
the display is flashing. When the loading has been successful, the display is briefly turned off to confirm.
• Step 5 – How to leave the programming mode
If there is no entry after one minute, the programming mode is automatically left. Furthermore, you can leave the
programming mode as described below:
Press the "Clear" button
OR
Press the "Voice" button
instead of the microphone button
0.6
function 06
, until the function number 00 is displayed.
, until the requested setup number (1 - 7) is displayed
to load the saved setup. Please make sure that the full stop after the right number in
.
and the "Requ" button
.
simultaneously for a few seconds (press the "Voice"
(refer to the table of programmable functions), which is
simultaneously (press the "Voice" button
43
. The full stop after the
first).