MCS 20 – MCS 221 Microphone Unit
3.
Microphone units
3.1 Safety information
General
• The microphone units provide a gooseneck microphone. Take care that you do not injure yourself on this e.g. poke it
into your eye.
• To align the gooseneck microphone on the microphone station and to avoid twisting it too far and causing
premature wear, always grip the microphone by the bottom flexible section never by the microphone head or by
the rigid tube. The gooseneck must be bent no further than an angle of 90 ° maximum.
Volume
• If the participants of the meeting use a headphone with the microphone units, please make sure that the volume
is not set too high. Otherwise the hearing of the participants could permanently be damaged.
• When the volume is set too high, acoustic feedback (howling) can occur.
Connection
• Make sure that the connector is tightly connected to the microphone unit. If it is loose it can cause interferences.
Exemption from liability
• beyerdynamic GmbH & Co. KG will not be liable if any damage, injury or accident occurs due to negligent,
incorrect or inappropriate operation of the product.
3.2 MCS 221 delegate microphone unit – controls and indicators
Rear view
Conference socket to connect to the next microphone unit or to the power supply unit
Headphone connection, mini jack (3.5 mm)
Conference socket to connect to the next microphone unit or to the power supply unit
32