Installation On The Wheelchair - Permobil ROHO Agility Max Mode D'emploi

Installation On the Wheelchair

Warnings:
- DO NOT perform any tasks without first reading and understanding all of the safety information and provided instructions.
- DO NOT remove or install the AGILITY while the individual is seated in the wheelchair.
- DROPPING, PINCHING, CRUSHING RISK: The AGILITY with Direct Mount Hardware is heavy. To avoid injury, hold securely and use
extreme caution when installing, adjusting, removing or otherwise handling the AGILITY with Direct Mount Hardware. Ask for
assistance if needed.
- After installation and adjustment is complete, and before the individual transfers into the wheelchair, make sure all hardware is
securely tightened. Refer to the recommended torque specifications. If the hardware is not securely tightened, the AGILITY may shift
up or down during operation, which could result in injury to the user or may reduce or eliminate the product's benefits.
To prepare for installation:
STOP: If the Direct Mount Hardware is NOT installed on the AGILITY, stop here and refer to
"Separately Purchased AGILITY - Installation of Direct Mount Hardware" in this manual.
1. Remove any existing wheelchair backrests:
Follow the Permobil Corpus instructions to remove the backrest
cushion and plates, as shown below.
a. Remove the backrest cushion, which is attached with hook
and loop fastener strips.
b. Remove the upper backrest
plate: Move the locking
mechanism catch outwards,
and then pull the section
straight up.
c. Remove the lower
backrest plate:
Remove the thumb
screw (or "knob"),
and then detach
the lower backrest
plate by sliding it
up and then away
from the four pins.
ROHO AGILITY Direct Mount Hardware Operation Manual
2. Check the Direct Mount Hardware Position: The Direct Mount
Hardware MUST be in the lowest position on the AGILITY in order
to attach it to the wheelchair. If you need to adjust the position
of the Direct Mount Hardware:
a. Loosen the nylon-
b. Make sure the bottom handle of the
c. Slide down the Direct Mount
d. Use the wrench to
6
insert lock nuts on the
AGILITY.
cover is attached to the cover with the
hook and loop fastener strip (or it can
be tucked into the lower flap). Make
sure the bottom handle of the cover
does not hang down.
Hardware on the AGILITY as far
as it will go.
tighten all four lock
nuts until snug.