Safety Information - KPS PA70 Manuel D'instructions

1.

SAFETY INFORMATION

Please particularly note that inappropriate use may cause shock or
damage to the meter when using. When using the meter, comply with
common safety procedures and completely follow the safety measures
stated in the operation manual. In order to make full use of the meter's
functions andensure safe operation, please carefully read and follow
the procedures in the operation manual.
The meter meets GB/T 13978-92 digital multimeter general technology condi-
tions, GB4793.1-1995 (IEC 61010-1, IEC 61010-2-032) electronic measure-
ment instrument safety requirements with secondary pollution and over-volt-
age standard of CAT IV 600V and CAT III 1000V. Please follow the safety
guidelines to ensure safe usage of the meter. The meter will provide satisfac-
tory services to you if you use and protect it appropriately.
1.1 Preliminary
When using the meter, the user should comply with standard safety rules:
- General shock protection
- Prevent misusing the meter
• Please check for damage during transportation after receiving the meter.
• If the meter is stored and shipped under hard conditions, please confirm if
the meter is damaged.
• Probe should be in good condition. Before use, please check whether the
probe insulation is damaged and if the metal wire is bare.
• Use the probe table provided with the meter to ensure safety. If necessary,
replace the probe with another identical probe or one with the same level of
performance.
1.2 Usage
• When using, select the right function and measuring range.
• Don't measure by exceeding indication value stated in each measuring ran-
ge.
• When measuring a circuit with the meter connected, do not contact with
probe tip (metal part).
KPS-PA70 • Digital clamp meter
WARNING
26