Safety Information; Safety Symbols; Safety Precautions - KPS -PA10 Manuel D'instructions

1.

SAFETY INFORMATION

The digital clamp meter has been designed according to IEC1010– 1 and
IEC1010–2–032 concerning safety requirements for electrical measuring
instruments and hand – held current clamps with overvoltage category 1000V
CAT II 600V CAT III and pollution 2.
2.

SAFETY SYMBOLS

Symbol
3.

SAFETY PRECAUTIONS

Follow all safety and operating instructions to ensure maximum personal
safety during the operation and to ensure the meter is used safely and is kept
in good operating condition.
• Read these operating instructions thoroughly and completely before operating
your meter. Pay particular attention to WARNINGS, which will inform you of
potentially dangerous procedures. The instructions in these warnings must
be followed.
• Always inspect your meter and test leads for any sign of damage or
abnormality before every use. If any abnormal conditions exist (i.e. broken
test leads, cracked cases, display not reading, etc.), do not attempt to take
any measurements.
• Do not expose the instrument to direct sunlight, extreme temperature or
moisture.
• Never ground yourself when taking electrical measurements. Do not touch
exposed metal pipes, outlets, fixtures, etc., which might be at ground
Meaning
Important safety information, refer to the operating
manual.
Dangerous voltage may be present.
Earth ground.
Double insulation ( Protection class 1000V CAT II 600V
CAT III ).
KPS-PA10 • Digital clamp meter
10