KPS PA70 Manuel D'instructions page 35

KPS-PA70 • Digital clamp meter
Note:
In the small voltage measuring range, the probe is not connected with the
circuit to be tested, and the meter may have fluctuating readings, which is
normal and caused by the meter's high sensitivity. This does not affect actual
measurement results.
3.2.7 Frequency
Measuring range
99,99Hz
999,9Hz
- Measuring scope: 10Hz~1kHz
- The input signal range: >20A AC (RMS) (input current will increase when the
frequency to be measured increases)
- Maximum input current: 1000A (RMS)
3.2.7.2 Through mode V:
Measuring range
99,99Hz
999,9Hz
9,999Hz
- Measuring scope: 10Hz ~ 10kHz
- The input voltage range: >20mV AC (RMS) (input voltage will increase when
the frequency to be measured increases)
- Input impedance: 10MΩ
- Maximum input voltage: 750V AC (RMS)
Resolution
0,01Hz
0,1Hz
Resolution
0,01Hz
0,1Hz
0,001kHz
35
Accuracy
±(1.5% reading + 5 digits)
Accuracy
±(1.5% reading + 5 digits)