Assembly; Bumper Bar; Cup Holder - Baby Trend JG50 Manuel D'instruction

ASSEMBLY

BUMPER BAR

WARNING:
use bumper bar to carry seat
with child inside. The bumper
bar is not a carrying handle.
8) • Attach the bumper bar by lining up
anchors with the slots on the seat. Push
until it clicks into place (Fig. 8a).
NOTE: The bumper bar must be securely
attached before using this product.
• To detach bumper bar, press the release
button on the bottom of the bar and pull
bar out of the anchor. Swing the bar
upwards to access the seat (Fig. 8b).
ATTATCHING THE SEAT
WARNING:
or run with your newborn in
the carriage position. Use for
strolling only.
• ONLY approved Snap Tech™ products can
be used on the frame.
9) • Make sure the seat fabric is properly
attached to the seat support bar. If the
seat fabric is unzipped, wrap the seat
fabric around the seat support bar (Fig.
9a) and zip the fabric closed.
• Attach the seat by lining up the seat
anchors on the side of the seat with the
anchors on the stroller frame and push
them together until they click securely
(Fig. 9b). The seat can face in either
direction, front or backwards.
7
Copyright © 2019, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
Do not
Never jog
TO ADJUST SEAT
WARNING:
upright position should be
used only for a child that is at
least 6 months old.
Fig. 8a 10) • The seat can be adjusted into upright,
reclined, and carriage position. Pull the
recline button on the rear of the seat and
rotate the seat into the desired position
(Fig. 10a).
Upright and Reclined Position: Buckle
the footrest and headrest straps on the
rear of the seat. Pull the excess straps to
tighten the seat (Fig. 10b).
Carriage Position: Make sure both
footrest and headrest straps are loosened
and extend the seat surround fully
(Fig. 10b).
REMOVABLE CANOPY
Fig. 8b
11) • To attach the removable canopy: Snap
the canopy clips on the inside of the
toddler seat tubes (Fig. 11a).
To open the canopy: push forward on the
front edge of the canopy while holding the
rear of canopy in place (Fig. 11b).
To fold the canopy: pull backwards on the front
edge (Fig. 11b).

CUP HOLDER

Fig. 9a
WARNING:
never put hot liquids in cup holder.
Avoid possible tipping, do not place
more than 1 lb. (0.45kg) in cup holder.
12) • To attach cup holder: slide the clip on the cupholder
over Cup Holder tabs on the Handle Bar. Push
untill firmly in place (Fig. 12).
Fig. 9b
Copyright © 2019, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
ASSEMBLY
The
To avoid burns,
Fig. 10a
Fig. 10b
Fig. 11a
Fig. 11b
Fig. 12 8