Baby Trend JG50 Manuel D'instruction page 4

ASSEMBLY
Remove stroller from box. The front wheel and
MUST
rear wheels be installed prior to use.
FRONT WHEEL
To attach the front wheel, unfold stroller as
described in the section following:
1) • Unlock the release lever (Fig. 1a) and
unfold stroller frame by pulling upward on
the stroller handle until the frame locks
(Fig. 1b).
• Lean the stroller backwards so that the
front wheel posts are pointing upward.
2) • Slide the front wheel onto the front forks
(Fig. 2).
3) • Slide the retainer plate onto the front
wheel. Be sure that the raised lip is
pointing toward the fork and insert it
into the slot on the fork. The tab on the
retainer plate must be lined up with the
slot before tightening the wheel (Fig. 3).
5
Copyright © 2019, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
Fig. 1a
Fig. 1b
Fig. 2
Slot Front Fork
Axel Nut Retainer Plate Axel and Hub
Fig. 3
4) • With the wheel in position, tighten the axel
nuts and tighten with standard crescent,
box, or open end wrench. You should
feel significant resistance and the wheel
should be held tightly in place (Fig. 4).
REAR WHEELS
5) • Lean the stroller forward to rest on the
front wheel.
• Press the rear wheel posts into the rear
frame hub until it clicks into place (Fig. 5).
NOTE: Pull on the rear wheel to ensure
that it is securely attached to the stroller.
TIRES
6) • Tires are shipped un-inflated. The tires
should be inflated on a regular basis to
the P.S.I. specified on each tire. Always
use a bicycle style hand air pump to
inflate the tires. *Not included (Fig. 6).
MULTI-POSITION HANDLE
7) • To adjust the handle, press the release
buttons to move the handle up or down to
a comfortable position for the user
(Fig. 7).
NOTE: Make sure the handle clicks into
place before using.
Copyright © 2019, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
ASSEMBLY
Fig. 4
Fig. 5
Fig. 6
Release Button
Fig. 7
6