Assembly - Baby Trend Falcon Jogger Manuel D'instructions

ASSEMBLY

CANOPY
• To attach the canopy: Line up the male
6)
fittings on the canopy with the slots
on the armrest and push both fittings
downward until snapped into place
(Fig. 6a). Align and join all hook
fasteners (Fig. 6b).
• To open the canopy: push forward on
the front edge of the canopy while holding
the rear of canopy in place (Fig. 6c).
• To fold the canopy: pull backwards on
the front edge (Fig. 6c).
• To remove the canopy: Press the snap
button on the side of the armrest in the
center of the cubic lock part, and pull to
release the fitting from the slot. Repeat
for the other side (Fig 6a).
7
Copyright © 2017, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
Snap Button
Fig. 6a
Hook
Fasteners
Fig. 6b
Fig. 6c
BUMPER BAR
WARNING:
Do not use
bumper bar to carry seat with
child inside. The bumper bar
is not a carrying handle.The
bumper bar is not designed to
hold the child in the seat.
WARNING:
The child should be secured
in the seat at all times by the
5-point restraining system.
• Attach the bumper bar by lining up
7)
anchors with the slots on the seat. Push
until it locks into place (Fig. 7a).
NOTE: The bumper bar must be securely
attached before using this product.
• To detach bumper bar, press the release
buttons on the bar and pull bar out of the
anchor (Fig. 7b).
Copyright © 2017, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits
ASSEMBLY
Fig. 7a
Fig. 7b
8
réservés.