Assembly - Baby Trend Expedition Double Jogger Manuel D'instructions

ASSEMBLY

• Line up the front fender and press onto
the front frame assembly (Fig. 5c).
• Insert the 4 screws through the
underside of the front frame assembly
into the front fender's plastic tubes.
Tighten the screws only until snug
(Fig. 5d).
DO NOT OVER TIGHTEN.
REAR WHEEL
6) • Lean the stroller forward to rest on the
front wheel. To attach the rear wheels,
push each wheel's axle into the plastic
corner fitting (Fig. 6). Depress the metal
lever on the inside of the corner fitting
as you push the axle into corner fitting.
When the wheel will not go on any
farther, release the lever.
NOTE: Check that the rear wheels have
locked into the corner fitting by pulling
on the wheels. If not locked, lift upward
on the levers, push the wheels in farther
and release the levers. This should allow
the rear wheels to lock into the corner
fitting.
• Ensure that the wheels are firmly
locked into place. NEVER use the
stroller if the wheels are not locked into
place, contact our customer service
department immediately at 1-800- 328-
7363, between the hours of 8:00am and
4:30pm PST, for assistance.
7
Copyright © 2018, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
PARENT TRAY
Fig. 5c
7) • To attach the parent tray, position the
• Snap the upper portion of the tray over
• Attach the lower portion of the parent
Fig. 5d
CANOPY
8) • To open the canopy: push forward
Lever
Fig. 6
WARNING:
Do not
place hot liquids or more
than 3 pounds in the parent
tray. Serious burns or
unstable conditions could
result.
parent tray in the center of the stroller
handle.
the handle (Fig. 7a).
tray to the cross tube, with the screws
provided (Fig. 7b).
on the front edge of the canopy. Push
downward on the tensioners to secure
(Fig. 8).
Copyright © 2018, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
ASSEMBLY
Snap
Fig. 7a
Insert screws
Fig. 7b
Open
Fig. 8
8