Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY
• Slide the retainer plate onto the front
3)
wheel. Be sure that the raised lip is
pointing toward the fork and insert it
into the slot on the fork. The tab on the
retainer plate must be lined up with the
slot before tightening the wheel (Fig. 3).
• With the wheel in position, tighten the
4)
axel nuts and tighten with standard
crescent, box, or open end wrench. You
should feel significant resistance and
the wheel should be held tightly in place
(Fig. 4).
REAR WHEELS
• Rest the stroller upside down, on the
5)
handle.
• Press the rear wheel posts into the rear
frame hub until it clicks into place (Fig. 5).
NOTE: Pull on the rear wheel to ensure
that it is securely attached to the stroller.
TIRES
• Tires are shipped un-inflated. The tires
6)
should be inflated on a regular basis to
the P.S.I. specified on each tire. Always
use a bicycle style hand air pump to
inflate the tires (Fig. 6). *Not included
5
Copyright © 2017, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
Front Fork
Slot
Axel and Hub
Retainer Plate
Axel Nut
Fig. 3
Fig. 4
Fig. 5
Fig. 6
PARENT TRAY
WARNING:
Do not
place hot liquids or more than
3 pounds in the parent tray.
Serious burns or unstable
conditions could result.
• To attach parent tray: line up the
7)
parent tray slots with corresponding
slots on the stroller frame and slide
down until locked into place (Fig. 7).
Note: Check to make sure the parent
tray is secure before using.
CANOPY
• To open the canopy: push forward
8)
on the front edge of the canopy while
holding the rear of canopy in place
(Fig. 8).
• To fold the canopy: pull backwards on
the front edge (Fig. 8).
SEATBACK POSITIONING
• The seat has a multiple position recline
9)
that is controlled by cords and adjuster
behind the seat. To recline the seat, pull
back on the loop of the adjuster while
simultaneously pressing the side button
(Fig. 9a). To place the seat back in a more
upright position, grab the adjuster with
one hand and pull the cords to the desired
position with the other hand (Fig. 9b).
The adjuster will lock automatically.
upright position should be used only for a
child that is at least 6 months old. Always
re-adjust the safety harness, including
the shoulder belts, when repositioning
the
seatback.
Copyright © 2017, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
ASSEMBLY
Fig. 7
Fig. 8
Fig. 9a
The
Fig. 9b
6
Publicité
Table des Matières
