Assembly - Baby Trend Go Gear Propel 35 Jogger Travel System Manuel D'instructions

ASSEMBLY

REAR WHEELS
5)
• Rest the stroller upside down, on the
handle.
• Press the rear wheel posts into the rear
frame hub until it clicks into place (Fig. 5).
NOTE: Pull on the rear wheel to ensure
that it is securely attached to the stroller.
TIRES
6) NOTA: check tires for correct inflation.
•
The tires should be inflated on a regular
basis to the P.S.I. specified on each
tire. Always use a bicycle style hand air
pump* to inflate the tires. *Not included.
(Fig. 6).
PARENT TRAY
WARNING:
place hot liquids or more
than 3 pounds in the parent
tray. Serious burns or
unstable conditions could
result.
7)
• Align the fittings on the ends of the
parent tray with the fittings on the
outsides of the handle. Pull outward on
the opposite end while pushing down
on the tray until locked onto the stroller
handle. Please be careful not to pinch
your fingers when installing the parent
tray (Fig. 7).
7
Copyright © 2018, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
Fig. 5
Fig. 6
Do not
Fig.7
CANOPY
8)
• To open the canopy: push forward on
the front edge of the canopy while holding
the rear of canopy in place (Fig. 8).
• To fold the canopy: pull backwards on
the front edge (Fig. 8).
SEATBACK POSITIONING
9)
• The seat has a multiple position recline
that is controlled by a cord and spring
loaded adjuster behind the seat. To
recline the seat, pull back on the loop
of the adjuster (Fig. 9a). To place the
seat back in a more upright position,
grab the adjuster with one hand and pull
the cord to the desired position with the
other hand (Fig. 9b). The cord will lock
automatically.
NOTE: The upright position should be
used only for a child that is at least 6
months old. Always re-adjust the safety
harness, including the shoulder belts,
when repositioning the seatback.
Copyright © 2018, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
ASSEMBLY
Fig. 8
Fig. 9a
Fig. 9b
8